The motor current flows as shown below when the Enable pin is high. To reverse the motor’s direction the 2 input pin’s values are reversed. Below shows the current path for the two Enable pin states when moving forward.Ĭurrent path when PWM on enable pin is HIGH in Forward direction.Ĭurrent path when PWM on enable pin is LOW (all 4 H-bridge transistors are off). Motor speed is determined by the modulation value of the PWM pin. Since ENA is using a PWM signal, the L289N will alternate between Forward (or reverse) and Coast columns of the L298N logic table. It connects the two inputs of the H-bridge to General Purpose Input/Output pins (GPIO) and the enable pin to a pulse width modulated pin (PWM). This mode alternates between driving the motor and disenabling the H-bridge (coasting).
It is a variation of sign-magnitude and is called by many names. The Drive/Coast Mode is the most common found connection method for the L298N when searching the internet on how to use the L298N on small robots. The Inputs / Output logic table for the L298N: PIN The symbolic circuit for one of the L298N’s two H-bridges is shown below and will be used for the rest of the article. The L298N uses NPN bipolar transistors for the H-bridge. The L298N integrated circuit surrounds the four transistor H-bridge with control circuitry that makes it easy to use and protects the H-bridge from damage such as shoot-through. Each H-bridge can control one DC brushed motor. It has a maximum current specification of 2.0 A per channel with a peak current of 3.0 A per channel (from STI spec sheet).
It is widely used on small inexpensive hobbyist robots. The L298N is a dual H-bridge chip often packaged nicely on a PCB module. Code examples will be for the Arduino Uno (or with small modifications the Mega2560).
This article discusses how to connect the L298 motor driver in three modes: drive/coast, sign-magnitude, and lock anti-phase.
0 kommentar(er)
